T-Motor tiger Prop 13"x5" 1*CW/1*CCW - set - black CF
These are the sublime T-Motor 13 x 5" high RPM props - 1 x CW(L) and 1 x CCW(R) low pitched multicopter props - amazingly - They require almost NO balancing - They are tough and quite.
Beautifully crafted Full Carbon Prop - suitable for hovering Ops - WARNING ! - these CF props are SHARP - user must take EXTRA CARE, carbon props in the wrong hands (yours) can cut and cause serious/permanent eye injuries - WEAR EYE PROTECTION such as polycarbonate sunnies. On the flip side they cut thru grass and leaves with ease if you encounter such things in your FPV adventures. Carbon props can shatter if they hit concrete or rocks !
The aerofoil design is efficient and gives long hover times - do not select these for fast high speed runs as they are VERY rigid - use triples for that
Super light weight 12grams/ prop + 3.1g for screws & top-plate - perfect for rapid speed changes - required to stabilise multiwiicopters
6mm ID centre - also comes with 5mm insert bushes if required
Requires 2.7mm shaft height(thickness of these props) you may need extra washer so your PA does not bottom out
These are high quality props and very efficient - but you must adhere to safety warnings about props below - always.
requirealmost NO balancing (we recommend to always check every prop and use 800 grit wet-n-dry to remove any sharp edges at the leading edge of the blades)
2 props 13x5" as you see in Photo at right - 1* CW(L) and 1*CCW(R) - Props are marked T-Motor - see photos
2 x top plate Adapter for the 12mmØ motors - the props have a 6mm centre hole - and outboard 12mm spaced mount points
2 x aluminium inserts 5mm for use on a t-motors ; 4 screws M3
Keep your PROPS OFF - not installed - until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - motors/PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible after you install props - make sure your actions and your Copter is safe before doing this. PROPS can CUT ! take precautions ! Never fly closer than 30m to/from any person or pet
This product hasn't received any reviews yet. Be the first to review this product!