Loading... Please wait...
Click the image above to see a larger version
  • drone Propeller balancer for multicopter video smoothing vibration removal AU NZ
  • drone Propeller balancer for multicopter video smoothing vibration removal USA
  • drone Propeller balancer for multicopter video smoothing vibration removal
  • drone Propeller balancer for multicopter video smoothing vibration removal
  • drone Propeller balancer for multicopter video smoothing vibration removal
  • drone Propeller balancer for multicopter video smoothing vibration removal

Propeller balancer for multicopter video smoothing vibration removal

$37.50
Shipping Weight:
300.00 Grams
Rating:

Sorry but this item is currently unavailable.

Please check back at a later stage.

Stock Remaining:
Out of stock


Product Description

Smooth props give smooth video & most importantly -> smooth Gyro/Acc/Mag/GPS performance.  Is your Quad or Hexii flipping out after 4-5mins - its most likely caused by residual vibration causing accumulated LEVEL spikes going to the CPU.  These propeller Balancers are the best & most accurate prop balancers you can get anywhere for MultiCopter props to balance them in 2D.  these are far more accurate than magnetic balancers for our EXTENSIVE  hands on balancing experience.  Some pilot try anything to avoid balancing including believe forum posts that some brands don't require balancing ? It's a myth - for video - all props must be balanced - thats the truth.

 

Features

  • Variable height for props up to 13" as shown ; or any size prop with offset table edge system
  • Indicates the 2D offset of the C of g by the position in which the prop stops - Add tape on the opposite side - if a prop stops at 45° tape must be added to the high side of the high prop !

 

Excludes

 
How to use?
Assemble the balancer as per photos this page - use pliers if the threads are tight on the up-rights - never use tools on the balance shaft - it must remain PERFECTLY straight and true - set up in a place with not wind or fans.  Cut some small strips of tape - twice the length of the prop width - about 10mm wide - can be electrical tape or holographic tape if you have it.
  1. Place the prop onto the shaft cones - held perfectly flat/true by the spring force - if the prop has blockers/luggs then ream them out first with a reamer
  2. Place the prop and balancer shaft onto the wheels of the balancer
  3. ensure nothing is binding - the prop should rotate freely with the tinniest force ; stop the prop then set it to 45°
  4. one blade will go to the bottom ; or the prop will hang level - both cases the prop is out of balance
  5. the prop blade at the bottom is heavier - mark it and add a small amount of balance tape to the top blade (the lighter one)
  6. rotate the prop to the 45° postions - ie top left - top right - bottom left - bottom right - it should stay perfectly still and not move at any position
  7. add or remove tape to achieve a balance
  8. if the prop always stops dead level - parallel to the table top - then the prop is balanced in one dimension (lengthwise along the prop) but not in 2 dimensions as it should
  9. in this instance you must add tape to the upper (lighter side) of both blades - or carefully scrape away material with a razor blade on the two bottom sides - be sure not to effect the aerofoil itself
  10. Usually for a given injection molded prop - the imbalance is the same - or near - for all replicants

Write your own product review

Product Reviews

  1. Easy to use, quality piece of kit

    Posted by Martin Ward on 23rd Nov 2014

    This is a really nice balancer. It's nicely weighty and easy to put together. The component parts have a nice quality feel to them. Excellent value for money.





Currency conversion