Sorry but this item is currently unavailable.
Please check back at a later stage.
This is an UPGRADE kit - DIY - OEM DJI Phantom motherboard Part #25 to allow direct connection of the Zemuse H3•2D gimbal controller to any Phantom v1 - After installing this kit your Phantom can directly control the H3•2D (without needing anything else like the patch solution v2 PMU is NOT then required) - Fits the v1 Phantom and RTF Phantom
Features - v2 PMU ; 8 Pin zenmuse connector ; 6 pin FPV video out connector ; tilt control for white Tx (if used)
1 x replacement internal USB / Pilots signals LED
1 x replacement main-board for direct connection of Zenmuse
1 x cables set for Zenmuse mini
1 x mounting tape for re-mounting existing NAZA
1 x RTF Tx white lever assembly (if using dji white Tx radio)
8 x screws
Excludes tools required = Allen keys ; Phillips ; Soldering Iron ; flux ; cable ties ; scissors
Requires soldering of All ESC wires
Requires the user dis-assemble the phantom to replace these boards.
Requires NAZA firmware 3.16 or later
Requires PC skills to re-configure/check everything afterward
Excludes training - user must follow printed instruction sheet included or online video below