Carbonbird™ Motor part 42.5mm - Shaft - OEM - for 1175kv 1/8th" 3.17mm
Replacement motor part - 1 x CarbonBird™ Motor shaft 42.5mm . 1/8th" 3.17mm - OEM CarbonBird™ replacement part - Fits the 1175kv series CarbonBird motors.
High quality steel shaft
Two circlip detent grooves
One Grub screw flat section - one side only - Use a Dremel tool to extend the keyway "flat" if required
size - the 3.17mm 1/8" shaft - 42.5mm long
Circlip detent spacing 12mm
1 x shaft only 3.17*42.5mm
NOTE : These are slightly shorter than the shaft used in the bigger 775 or 888kv motors which are only 46.6mm long
Setup Tip : Always use loctite carefully in the grub screw - the smallest drop is correct amount - wipe away excess - do NOT allow loctite to enter bearings
Removing a Grub Screw : ALWAYS HEAT THE MOTOR grub screw FIRST with a hair-dryer on hot (or if you have a temperture controlled heat gun set to <100°C) - When hot - Loctite thread glue will become very soft and easy to un-do!! Do this heat
Exclude tools - requires a flat surface , hammer, 3 mm tap, 1.5mm Allen key, Circlip pliers, long nose pliers, Dremel tool, Oil , loctite™ blue
This product hasn't received any reviews yet. Be the first to review this product!