Below are the available bulk discount rates for each individual item when you purchase a certain amount
These are our OEM SILVER 3 Petals 6mm CarbonBird® Collet shafts for crash replacement for RED 6mm SYSTEM ASSEMBLY (does not fit the economy silver collets) - so if bent replace only this part - With Multicopters it's critical to have a 100% perfect straight/true collet shaft to ensure the prop is rotating dead-centre. In the event of impact the CarbonBird motor shaft will usually fail at the machined failpoint (small groove machined into the shaft) but if the shaft is reversed then these force can be absorbed by the Collet (this item) and it may be off centre - and is best replaced.
Dimension & Data
OEM Carbonbird collet - SILVER 3 petals type 6mm
OD M5 threaded shaft 28mm L ; threaded section 12.5mm
Note : a Collet must be attached to a motor shaft with loctite™ ; to Remove a collet , remove the spinner, remove the prop and lower red collar, then first heat the inner collet to 145°C with a heat gun (avoid heating magnets) then the loctite will be very soft and the collet will release from the shaft - To remove dried loctite, use the solvent Acetone - normally just place the removed collet in acetone for 20 mins and it will be very soft and wash away easily.
One SILVER aluminium Shaft ONLY 6mm
Excludes other parts of the collet assembly; M6 nut ; Tapered lock ; Spinner - re-use these other parts from original supplied with your motor
Excludes Loctite glue
*NOTE : Its possible to bend an aluminium collet straight by first spinning it - marking the side which is running wide with a permanent ink marker - then bending it away from the mark by the same amount - be aware that metal fatigues oif bent back too many times and may fail.