Loading... Please wait...
Click the image above to see a larger version
  • Carbonbird™ Motor part - drone Bearing - set of 2 OEM - EZO for 775kv 1175kv 1220kv 1/8th" 3.17mm series
  • Carbonbird™ Motor part - Bearing - set of 2 OEM - EZO for 775kv 1175kv 1220kv 1/8th" 3.17mm series
  • Carbonbird™ Motor part - Bearing - set of 2 OEM - EZO for 775kv 1175kv 1220kv 1/8th" 3.17mm series

Carbonbird™ Motor part - Bearing - set of 2 OEM - EZO for 775kv 1175kv 1220kv 1/8th" 3.17mm series

$2.25
Shipping Weight:
26.00 Grams
Maximum Purchase:
10 unit(s)
Stock Remaining:
22


Product Description

Set of 2 x CarbonBird™ Motor bearings. EZO brand - OEM replacement part - Fits the 775kv 1220kv 1175kv series CarbonBird™ motors.
Also fits the bell side of the newer ribbed red/black CarbonBird ; post July 2013 Series motors 888kv ; 775kv ; 1175kv.

 

Features

High quality Japanese EZO bearing - there is simply no better bearing - anywhere in this size.  Difficult to source - we have them !!  

size - fits the 3.17mm 1/8" shaft - 7.8mm Od - 3.5mm depth

 

Notes

  • requires oil - one drop on installation - 1 drop every 5 hours running - remove all excess
  • never expose to moisture or Loctite - do not try to install with any kind of Loctite - NOT permitted - Loctite entering any bearing will permanently damage it.
  • can be damaged by metal hammer blow forces on the side - always use a plastic mallet - and nylon tap  - to remove old bearings - motor must be apart - hold the stator section by hand - NEVER in a vice - tap lightly with a plastic mallet - nylon punch
  • for full motor care  - see motor care page - CarbonBird motors 
  • can be damaged in minutes if exposed to high harness - micro-size abrasive sand/dust particles - choose your take offf and landing zones carefully !
  • put a small circumference of industrial grease in the outer edge  of the stator,  then push bearing in - don't put grease into the bearing itself - bearing runs on auto oil 20W50 - this vicosity works very well - also later the bearing can be changed easily if grease is used - we don't recommend loctite go anywhere near bearings
  • Set the pressure of the shaft correctly - bearings are held in under axial compression run smooth and silent if the axial pressure of the delrin washer (against the distance to the grub screw)  is correct ; if the shaft depth-to-grub-screw is too tight the engine will not spin freely - if the pressure is to loose and the engine has free play the engine will vibrate against the cogging forces of the magnets

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!




Currency conversion