Loading... Please wait...
Click the image above to see a larger version
  • Bearing set, NMB Japan - fits 3100kv Red/Black series
  • Bearing set, NMB Japan - fits 3100kv Red/Black series

Bearing set, NMB Japan - fits 3100kv Red/Black series

$2.75
Shipping Weight:
45.00 Grams
Stock Remaining:
99


Product Description

Set of 2 x CarbonBird™ Motor bearings - NMB replacement part - Fits the RED/BLACK "mini" Series of motors released July 2014->   including 3100kv    

 Features

High quality NMB USA bearing 

size - fits the 3100kv CarbonBird - be sure to check your motor and compare to the photo above first

1 x small top bearing 

1 x small bottom main bearing 

 

Important Notes

  • Keep away from sand and dusty areas - a few minutes hovering around in abrasive dust can damage your bearings!
  • Bearings require oil - one drop of oil on installation - 1 drop every 5 hours running - wipe away excess.
  • Professionals Plan ahead - keep some spare bearing on hand in advance, and/or keep a spare motor on hand.
  • Bearings are sometimes mistaken to be faulty when the issue is a incorrect SHAFT depth tension setting (shaft is set to short or with play) Motor noises can also start from a dusty/sandy take-off or landing , or a crash or pilot assymetrical tool forces on the collet, which bends the prop-shaft or collet or both - be sure to check trueness of the shaft if bearing replacement does not have an immediate effect of reducing motor noise.
  • never expose to moisture or Loctite - do not try to install with any kind of Loctite - High risk! - Loctite entering any bearing will permanently damage it!
  • can be damaged by metal hammer forces on the side - always use a plastic mallet - and Aluminium tap  - to remove old bearings - motor must be apart - hold the stator section by hand - NEVER in a vice - strike with a plastic mallet - nylon punch
  • for full motor care  - see motor care page - CarbonBird motors 
  • can be damaged in minutes if exposed to high hardness particles - micro-size abrasive sand/dust particles - choose your take off and landing zones carefully !  We recommend carry a large mat and using that as a LZ
  • put a small circumference of industrial grease in the outer edge  of the stator,  then push bearing in - don't put grease into the bearing itself - bearing runs on auto oil 20W50 - this vicosity works very well - also later the bearing can be changed easily if grease is used - we don't recommend loctite go anywhere near bearings
  • Set the pressure of the shaft correctly - bearings are held in under axial compression & run smooth and silent if the axial pressure of the delrin washer(against the distance to the grub screw)  is correct ; if the shaft depth-to-grub-screw is too tight the engine will not spin freely - if the pressure is too loose and the engine has free play the engine will vibrate against the cogging forces of the magnets

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!




Currency conversion