High RPM Super-Nylon Prop suited to Multicopters running very High RPMs with strong MOTOR cooling as a feature of the design. The low tip loading and solid inboard root airflow this prop gives extra stability compared to other designs - Made in Germany by Graupner these props by design have very steep inboard section and rapid taper chord-wise - provides slightly less thrust overall compared to a similar hover flyer prop (spoon) but provides superior high-speed fast forward flight in multicopters due to the high 8" pitch. Very Rigid & strong prop - Suits experienced prop balancing FilmMaker - not for Noobs doing film Ops.
WARNING : Props can cut !! Due the the large size and strength - be aware these props must be treated with care due to risk of injury !! - All multicopter should be operated 30m away from persons
1 x 14x8 eProp Graupner - (R) CCW 1326.14x8
Requires balancing by the pilot - this includes 2D chord-wise balancing and span-wise balancing using a prop-balancer HERE - not suited to Noobs for this reason.
Requires a 8mm OD Prop Adapter or shaft here for smaller shafts - not included
Excludes training on how to balance props for video Ops
Excludes Prop Collets /Prop adapters which comes with the motor itself
Keep your PROPS OFF - not installed - until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a Noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. When operating props remain clear of the spinning arc plane - at all times wear eye protection.